Regency Fireplace Products PG33-NG Operations Instructions download pdf (Page 10)

10

Regency IG34 Gas Inbuilt Fireplace

INSTALLATION

Conversion Kit #486-968 for NG to LPG Model

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER

IF IN DOUBT DO NOT DO THIS CONVERSION !!

C

onversion Kit 486-968 Contains:

Q

ty. Part # Description

1 904-345 Burner Oriﬁ ce #51

1 918-273 Red "LPG" label

1 918-272 Label "Converted to LPG"

1 910-037 LPG Pilot Injector

1 918-823 Instruction Sheet

1

) Shut off the gas supply and unplug

the power cord.

2

) Remove the glass door, logs and

lava rock.

3

) Remove the rear log tray by remov-

ing the 2 screws. (Log tray must be

rotated to clear the burner.)

4

) Remove the grate.

5

) Remove the burner and ensure the

aeration setting is 13 mm open.

6

) Remove burner oriﬁ ce with a 1/2"

wrench and discard. Use a wrench

to hold on to the elbow behind the

oriﬁ ce.

Control Box

Cover

Antenna

Jumper Location

16) Remove the jumper using a plier.

7

) Reinstall new burner oriﬁ ce LPG

stamped #51 and tighten.

8

) Apply the conversion label "This

unit has been converted to ULPG"

over top of the serial number decal.

12) Replace the yellow "NG" label with

the red "ULPG" label.

13) Carefully pull out the control box.

NOTE: The control box is held in

place with velcro.

14) Remove the heat shield from the

control box by removing the 2

screws.

15) Remove the control box cover by

undoing the 3 screws.

Manoeuvre through antenna.

17) Reverse steps 13, 12, 11, 6, 5, 4, 3

& 2.

Note: Aeration settings do not need

to be adjusted.

Burner

9) Pull out the pilot hood by hand.

Pilot

Hood

11) Put in the new LPG oriﬁ ce with the

allen key. Then put back the pilot

hood.

Pilot

Hood

removed

10) Remove the pilot oriﬁ ce with the

allen key.

Pilot

Oriﬁ ce

Jumper

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments