Regency Fireplace Products PG33-LPG Operations Instructions download pdf (Page 30)

Regency

®

PG36-4 Gas Log Fireplace

30

OPERATING INSTRUCTIONS

During the ﬁ rst few ﬁ res, a white ﬁ lm

may develop on the glass front as part

of the curing process. The glass should

be cleaned or the ﬁ lm will bake on and

become very difﬁ cult to remove. Use a

non-abrasive cleaner and NEVER clean

the glass while it is hot.

FIRST FIRE

The FIRST FIRE in your heater is part of the

paint curing process. To ensure that the paint

is properly cured, it is recommended that you

burn your ﬁ replace for at least four (4) hours the

ﬁ rst time you use it with the fan on.

When ﬁ rst operated, the unit will release an

odour caused by the curing of the paint and

the burning off of any oils remaining from

manufacturing. Smoke detectors in the house

may go off at this time. Open a few windows to

ventilate the room for a couple of hours. The

glass may require cleaning.

NOTE: The main burner will always start on

"HIGH" and resume it's last setting after

20 seconds of operation.

NOTE: When the glass is cold and the appliance

is lit, it may cause condensation and fog

the glass. This condensation is normal

and will disappear in a few minutes as

the glass heats up.

DO NOT ATTEMPT TO CLEAN THE

GLASS WHILE IT IS STILL HOT!

DO NOT BURN THE APPLIANCE

WITHOUT THE GLASS FRONT IN

PLACE.

LIGHTING

INSTRUCTIONS

1) Plug the power cord into a power outlet.

2) Press and release the ON/OFF button once

to start the unit.

3) After approximately 3 seconds the spark

ignition system will spark for 40 seconds to

light the main burner.

4) If the main burner does not light, reset the

unit.

RESETTING

THE UNIT

1) Open the bottom louvre of the unit.

2) Press and release the reset button, located

on the unit's control panel once.

3) Wait for approximately 3 seconds and the

pilot sparks can be heard and seen. It would

take 2 to 3 seconds for the ﬂ ame to be lit.

NOTE: A period of 30 seconds must pass before

another reset is attempted.

SHUTDOWN

INSTRUCTIONS

1) Press the ON/OFF button once.

2) Turn off all electric power to the appliance if

service is to be performed.

OPERATING

INSTRUCTIONS

Before operating this appliance, proceed through

the following check list.

1) Read and understand these Instructions

before operating this appliance.

2) Check to see that all wiring is correct and

enclosed to prevent possible shock.

3) Check to ensure there are no gas leaks.

4) Make sure the three pieces of door glass

are properly positioned. Never operate the

appliance with any of the glass removed or

with the door open.

5) Verify that all flueing and the cap is

unobstructed.

6) Verify log placement.

REMOTE CONTROL

Use the Regency

®

Remote Control Kit approved

for this unit. Use of other systems may void

your warranty.

The remote control kit comes with a hand held

transmitter and a wall mounting plate.

1) Choose a convenient location to mount

the hand held transmitter, protection from

extreme heat is very important.

The remote can also be used as a wall

thermostat.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Comments to this Manuals

No comments