Regency Fireplace Products B36XTCE Installation Manual download pdf (Page 5)

Regency B36XTCE Gas Fireplace

SAFETY LABEL

This is a copy of the label that accompanies

each Bellavista™ B36XTCE Direct Vent Gas

Fireplace. We have printed a copy of the

contents here for your review.

NOTE: Regency

units are constantly being

improved. Check the label on the unit and if

there is a difference, the label on the unit is

the correct one.

COPY OF SAFETY DECAL

For the State of Massachusetts, installation

and repair must be done by a plumber or

gas ﬁ tter licensed in the Commonwealth of

Massachusetts.

For the State of Massachusetts, ﬂ exible

connectors shall not exceed 36 inches in

length.

For the State of Massachusetts, the appli-

ances individual manual shut-off must be a

t-handle type valve.

The State of Massachusetts requires the

installation of a carbon monoxide alarm in

accordance with NFPA 720 and a CO alarm

with battery back up in the same room where

the gas appliance is installed.

DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE

410

DOOR SEAL: Please

check that the door is

properly sealed

FPI Fireplace Products International Ltd. Delta, BC, Canada

Minimum Clearances to Combustibles /

Degagement Minimum De Materiaux Combustibles

Serial No./ No de serie

919-153

MAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.

Listed:

Certified for/Certifi e pour:

Tested to:

VENTED GAS FIREPLACE HEATER /

CANADA and U.S.A.

FOYER AU GAZ À ÉVACUATION

CAN/CGA-2.17-M91(R2009)

ANSI Z21.88-2009/CSA 2.33-2009

Electrical supply/Électrique 115VAC, 1.13 A, 60Hz.

NOT FOR USE WITH SOLID FUELS. /

NE PAS UTILISER AVEC DU COMBUSTIBLE SOLIDE.

Made in Canada/ Fabrique au Canada

Duplicate S/N

0" Clearance to

combustibles from:

Mantel Clearances from

Fireplace Opening:

Side Wall Clearance

from Fireplace Opening

Ceiling from Top of

Fireplace Opening:

Mantel Depth:

Alcove Clearances:

Sides, bottom and rear of unit

(A) Min. 15-1/2" (394mm)

B) Min. 12” (305mm)

C) 39” (991mm)

D) Max. 12” (304mm)

F) Max. Depth 36" (914mm)

*Top - 3-1/2" (89mm) non-combustible

material required above unit.

(on one side)

E) Min. Width 84" (2134mm),

(See Instruction Manual for

detailed instructions)

ÉÉ

QUIP A L'UISINE POUR GAZ PROPANE

CONCU POUR ETRE POELE: Mod le B36XTCE-LP

PROPANE GAS: Model B36XTCE-LP

Minimum supply pressure

Manifold pressure high

Manifold pressure low

Orifice size

Minimum input

Maximum input

Altitude

NATURAL GAS: Model B36XTCE-NG

APPAREIL FONCTIONNANT AU NATURAL GAS

CONCU POUR ETRE POELE: Mod le B36XTCE-NG

Pression d'allimentation minimum

Pression à la tubulure d' chappement lev e

Pression à la tubulure d' chappement basse

Grandeur de l'injecteur

D bit minimum selon

D bit maximum selon

l'altitude

Calorifique

ééé

5.0" (1.25 kPa)

3.5" (0.87 kPa)

1.6" (0.40 kPa)

#35 DMS

0-4500 ft/pi (0-1372 m)

WC/C.E.

21,500 Btu/h (6.3 kW)

31,000 Btu/h (9.09 kW)

Pression d'allimentation minimum

Pression à la tubulure d' chappement lev e

Pression à la tubulure d' chappement basse

Grandeur de l'injecteur

D bit minimum selon

D bit maximum selon

l'altitude

Calorifique

ééé

11" (2.74 kPa)

10" (2..49 kPa)

6.4" (1.60 kPa)

#51 DMS

0-4500 ft/pi (0-1372 m)

WC/C.E.

25,000 Btu/h (7.33 kW)

31,000 Btu/h (9.09 kW)

Minimum supply pressure

Manifold pressure high

Manifold pressure low

Orifice size

Minimum input

Maximum input

Altitude

This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.

This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the

United States, or when such a standard is not applicable, ANSI/NCSBCSA225.1/NFPA501A, Manufactured Home Installations Standard orANSIA119.2 ou NFPA 501C Standard for Recreational Vehicles

This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See

owner's manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used. (Kit #576-972).

Fan Part # 576-917.

Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installationANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur.

Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety

Standard. Si ces normes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational

Vehicles.

This vented gas fireplace heater is not for use with air filters. Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.

FOR USE WITH GLASS DOORS CERTIFIED WITH THE APPLIANCE ONLY

Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure si les

règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est fournie.

POUR UTILISATION UNIQUEMENTAVECLES PORTES EN VERRE CERTIFIÉES AVEC L'APPAREIL

4001172

Floor

Wall

Ceiling

1 2 3 4 5 6 7 8 9 10 ... 71 72

Comments to this Manuals

No comments

Regency Fireplace Products B36XTCE Installation Manual Page 5

Comments to this Manuals

Related products and manuals for Fireplaces Regency Fireplace Products B36XTCE